300kg Electric Power Waste Copper Wire Granulator Copper Wire
TF series Cable wire recycling machine process the waste electric
wire and cable into copper and plastic granule. Copper is separated
from the plastic, separation efficiency can be 99%. For the copper
granule, it can be sold directly or go to further refining. Through
our copper electrolysis machine, the copper can be refined into
cathode copper in above 99.99% purity. The plastic granules
normally are PVC or rubber material, it can also be sold directly.
Copper wire recycling machine advantages:
1. Integrated structure, small dimensions, easy to move, saving
2. Low power consumption, stable performance.
3. Minimum copper recycling rate can reach 99%.
4. No water is needed, no dust, no environmental pollution.
5. Controlled by electricity control panel, highly automatic.
Scrap Copper Granulator Application:
The Household and Industrial Copper Wire Recycling Machine is dry
type structure, mainly used to all kinds of waste copper wire, the
copper wire will be separated into tiny copper rice and PVC. This
machine can recycle the copper wire which diameter is 0.3mm-20mm.
Automobile electrical wire or the electric wire of car, motorcycle
electric wire, computer case wire and communication cable, etc
Electric Copper Wire Recycle Machine Specifications:
|Model||Recycling capacity||Processed wire dia.||Total power||Voltage||Dimension||Weight|
Automatic Recycling Machine Working principle:
For the small capacity, the cable wire raw material can be put into
the all-in-one machine directly, after crushing, then the air
separator will make the copper and plastic suspended on the screen.
Then the Copper will be separated from the plastic by weighting
method and the friction force which produced by the Surface of the
1.Put wires and cables into the crusher, in which they are crushed
and plastic sheath and copper separated completely. The length of
the crushed material is based on the mesh of the riddle: the bigger
the mesh is the longer the crushed material will be and the larger
the output will be. The mesh should be chosen in production
according to the type of the material.
2.The crushed material (mixture of copper granules and plastic
pieces) is conveyed to the separator by the conveyor, during which
procedure dust and part of plastic pieces of light weight(including
fiber, rope, or tapes, etc. mixed in the wires) are collected by
the pressure-reducing blower. The above opening of the pressure
reducing blower is connected with the dust collector opening in
which a dust collecting bag is used to prevent discharge of dust
for the purpose of environmental protection. Dust and part of
plastic pieces of light weight are collected in this bag and will
be discharged when the bag is full.
3.The separator is used for separating plastic pieces and copper
granules. According to the differences of the physical properties
and specific gravity between different materials, there is specific
gravity deviation under the forces of Aerodynamic and Vibration
friction. By adjusting the speed of material conveying and
amplitude parameters, copper granules (of larger specific gravity)
will move to the riddle bottom and move from down to up, and
plastic pieces (of smaller specific gravity) will move to the above
of copper granules and move from up to down, and in the end they
will both be discharged through different openings.
4.All the units are installed on the underbed to form a whole
structure. The machine is adjusted ready for production before
shipping, and the customer only need to connect it to the power